![]() I have seen some patch fixes from the likes of ASRock and a few others where you can install onto a Skylake chip. I am at a complete loss other than taking my PC to a specialist and paying for them to fix it or even a way around Windows 7 and getting that installed. So basically I am unable to use my PC as the lockup occurs, I have tried a clean install of Windows 10 (Locks up when Installing that too) (My grandma could do a better job with the space shuttle than they could do making a OS.) I hav gone through everything even going as far as to speaking to Microsoft technical support as they are ****ing useless. As soon as I power on and then sit and wait, go to open a program and then it locks up again. My computer has locked up over 9 or 10 times. ![]() ![]() I ended up fixing that problem through my nvida nvcuda.dll thought great. I tried to start the game via Steam but I got that horrible lock up, cant use mouse everything freezes can't use keyboard, HARD reset time. Great I thought, I then purchased a recent game called Squad. I fixed these within the 3D control panel there was a error as I am running SLi Cards. So I bit the bullet and upgraded to Windows 10, All was fine for about the first 2 days, after that I was getting nVidia drivers crashing. I wanted to install my OEM copy of Windows 7 64-Bit Ultimate but somehow it doesn't accept the disk, brings up the launch menu and everything to install then it comes up with a error and says some files are missing. I build a brand new custom PC, I went down the Skylake route, which now I am actually regretting. Want to read more answers from other tech-savvy Stack Exchange users? Check out the full discussion thread here.Evening All, I signed up to these forums, as I am too having trouble with Windows 10 basically locking up my whole PC and m having to do a complete Hard Reboot. Have something to add to the explanation? Sound off in the comments. If you can, strongly consider remounting the source file system as read-only before starting the second rsync run (something like mount -o ro,remount /media/source should do). Thus, you can feel free to use the computer normally during the first run, but should avoid making any changes as much as possible to the source during the second run. The second run should transfer only differences that happened during the previous rsync run, and as such, will be completed much faster. Doing so will cause rsync to re-scan the source and transfer any differences that were not picked up during the original run. Once rsync has finished, run it again with the same parameters (unless you have some funky deletion parameter if you do, then be a bit more careful). There is an easy way around that, however. That depends on the type of change, whether rsync has scanned that particular directory yet, and whether rsync has copied the file or directory in question yet. “Write” is anything that modifies the content of the source directory or any subdirectory thereof, so that includes file updates, deletions, creation, etc.ĭoing so will not actually break anything, but the change may or may not actually get picked up by rsync for copying to the target location. ![]() What is not generally safe, however, is to write within the source directory while rsync is running. It is also safe to read within the target directory, especially if the target directory is being populated exclusively by the rsync run. SuperUser contributor Michael Kjorling has the answer for us:Īs others have already pointed out, it is safe to read from the source disk or use the target disk outside of the target directory while rsync is running. Is it safe to use a hard drive while rsync is running? The Answer ![]()
0 Comments
Leave a Reply. |